Hello -

I wanted to know if we can have a fully dynamic sub-reports in CR. I will explain my scenario below..please let me know how i should proceed. I have two sub-reports which uses two different stored procedures to get the required data. Both the stored procedures will take three parameters each.

Sub-Report1: AIM.rpt which uses stored procedure "aim_sp"
Sub-Report1: IND.rpt which uses stored procedure "ind_sp"

aim_sp will take "start_dt","end_dt" and "unit" as parameters
ind_sp will take "start_dt","end_dt" and "unit" as parameters as well.

My requirement is to get the required parameters from the main report(main.rpt). These two sub-reports are shown using this blank report file. The only functionality of the main.rpt is to embed the two sub-reports and get the three parameters. And then, pass the parameters from main report to the two sub-reports. And then, the sub-reports will use the two sub-reports to run the stored procedures and get the data dynamically.

What i did??
----

I created the blank main.rpt file and created three parameters. And then i attached the sub reports to the main report. The sub-reports are themselves seperate report files which have stored procedure as database fields. But when i refresh the main report, it is totally looking for nine parameters. Three are from the main report file. Next three are from the stored procedure "aim_sp" and the next are from "ind_sp".

How can we link the main report parameters to all the sub-report parameters in the back ground and let it ask only three parameters?

Please advice me...
THanks,